toyota camry sun visor replacement beige right

(There is NO NEED to remove the adhesive backing from the Velcro strip)ĥ) Carefully mount the visor so that one of the mounting screws also goes through the Velcro strip 6) Be sure that the sticky side of the Velcro strip faces down or towards the visorħ) Once the visor is loosely mounted, pull the Velcro strip slightly and then tighten the 2 mounting screws securely. 3) Remove the 2 Phillips screws and drop the visor down slightly so that you can unplug the wires that go to the visor light and now remove the visor 4) Using the plastic velcro strip ONLY, (NOT the fuzzy strip), trim the end of the strip so that it will fit under the visor mount and also punch a small hole in that end of the strip so that one of the screws will go through it. To resolve this problem follow the following steps:ġ) Go to the hardware store and purchase the Velcro package that contains (2) 18”, 1/2 inch strips (I chose the beige color since I have a tan interior) 2) Using a small screw driver, carefully pry off and remove the small cover that hides the mounting screws for the Driver’s visor. It cost me a total of $2.69 and about 30 minutes to fix. This problem is primarily caused by the heavier than normal visor. I resolved this same problem on my 2004 Murano after also being told that it ($350 Visor) was not covered under my extended warranty. SOURCE: Sun visor on 2005 Nissan Murano won't stay up/falls down

Toyota camry sun visor replacement beige right